Rocol Dry Moly Spray 10025 tb133h
	Resin bonded, dry film coating of molybdenum disulphide in aerosol. Developed to lubricate sliding mechanisms such as plain bearings, pins, cams and slides where a wet lubricant cannot be tolerated. FEATURES Temperature range of applied film -200 C to 450 C Dry film lubrication - resists pick up of contaminants Prevents galling, pick up and seizure Resistant to high loads (up to 7,000 kg/cm2) Excellent wear resistance (high molybdenum disulphide content) DIRECTIONS FOR USE For best results apply at ambient temperatures. Ensure surfaces to be treated are clean, dry and free from oil, grease or dirt contamination. Shake can thoroughly for 2-3 mins after agitator ball begins to rattle. Hold upright and apply a thin even coating from approx 15 -30cm (6-12 inches) away from the surface. After use invert can and spray until nozzle is clear Film will be touch dry in 2-3 mins and completely cured in approx 3 hours. The cured film can be improved by lightly burnishing with a lint free cloth.